1/4-Inch Carbide Double Cut Burr for Tire Repair Dressing with Adapter

Introduction

One of the main steps in the Rubber Manufacturer’s Association tire repair procedure for pneumatic tires is to make sure the tire injury has been cleaned out in preparation for a plug stem or plug stem patch. The STEELMAN 18241A 1/4-Inch Carbide Double Cut Burr for Tire Repair Dressing with Adapter is designed for that specific step of tire repair. A 2mm hex set screw holds the carbide burr firmly in place inside the adapter which can then be swapped into a 3/8-Inch quick change chuck on a low speed tire buffer tool and used to create a clean, smooth, and uniform repair channel through tire rubber and the embedded steel belts without the risk of friction scorching that could further weaken the tire. The double cut design allows this cutter to remove material on both the insertion and removal parts of each stroke speeding up total repair time. The durable carbide steel burr features flats along the shaft ensure that when fitted into the adapter, the set screw has secure purchase and will keep the burr from being seized by the tire material and ceasing to turn.